PhilC Designs :: View topic - TS 7.6 Pipe Extrusion Tool.


 

 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
  Plug-ins, Content & Tutorials for Poser
TS 7.6 Pipe Extrusion Tool.

 
Post new topic   Reply to topic    PhilC Designs Forum Index -> Truespace
View previous topic :: View next topic  
Author Message
patlane



Joined: 07 Apr 2015
Posts: 2

PostPosted: Wed Apr 08, 2015 9:34 pm    Post subject: TS 7.6 Pipe Extrusion Tool. Reply with quote

Now, i am a TrueSpace die hard. I use 7.6 but seriously contemplating going back to version 6? Some of the extrusion tools seem to get confused such as when moddeling pipework and where a 45 degree bend is required. Select the model, face, select the degree and segements and...... nothing happens?? There are several other buggy tools incorporated into the interface as well. Now i would point the problem of running the application on a 64 bit system but TS 6+ chugs along without these problems. ...i blame microsoft..
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    PhilC Designs Forum Index -> Truespace All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Forum software by p h p B_B © 2001, 2005 p h p_B B Gr0up